After-Sales Section
Q6: What should I do if MDF warps or deforms?
A: MDF warping or deformation is usually related to raw material control, fiber moisture content, board density, mat formation uniformity, hot pressing parameters, and post-treatment. If warping is found, please contact JINDIWOOD after-sales within the warranty period. Our "full after-sales guarantee" covers such quality issues.
Q7: What causes a rough surface or sanding marks on MDF?
A: MDF has very high requirements for surface quality, especially when surface decoration is applied, where a flat and fine surface is essential. A rough surface or sanding marks are usually related to improper control of the sanding process. JINDIWOOD uses a fine sanding process (180–240 grit sanding belts), ensuring surface roughness Ra ≤ 3.2 μm and thickness tolerance within ± 0.15 mm.
Q8: How is the screw holding strength of MDF?
A: MDF has an internal bond strength ≥ 0.55 MPa, with good screw holding. Face screw holding can reach 700–1000 N. However, edge screw holding is relatively weaker. It is recommended to install hardware on the panel face as much as possible. If edge installation is required, pre-inserted nuts or additional connectors are recommended for reinforcement.
Q9: Can MDF be used for extra-high cabinet doors?
A: MDF can be used for cabinet doors, but extra-high doors over 1.9 m have a deformation risk. Recommendations: ① choose high-density MDF (≥ 800 kg/m³); ② increase door thickness (≥ 22 mm); ③ install a straightener on the back of the door; ④ choose a moisture-resistant product and ensure proper edge sealing.
Q10: What is the warranty policy for JINDIWOOD MDF?
A: JINDIWOOD MDF provides a 12-month warranty from the date of arrival. For quality problems such as insufficient internal bond strength, severe warping deformation, or large-area surface defects, we offer full compensation and cover the replacement shipping cost. Damage caused by improper use in humid environments or improper processing is not covered by the warranty.


